ROTALK Forum
Welcome, Guest
Ask the community for their best thinking on your 912/914 series Technical Questions.
Topics [912 / 914 Technical Questions]
-
servo issue
- by Robert Mykytiuk
- in 912 / 914 Technical Questions
- 2 years ago.
- Last replied by Robert Mykytiuk
- • 2 replies
-
Rotax engune Serial Numbers
- by Angus Fleming
- in 912 / 914 Technical Questions
- 2 years ago.
- Last replied by Rotax Wizard
- • 1 reply
-
914 cuts out passing 5200 rpm
- by Bob Stern
- in 912 / 914 Technical Questions
- 2 years ago.
- Last replied by Sean Griffin
- • 1 reply
-
Longer Plug Wires
- by Scott Tyree
- in 912 / 914 Technical Questions
- 2 years ago.
- Last replied by Rotax Wizard
- • 12 replies
-
High oil pressure on 912 ULS
- by Rick Hildebrand
- in 912 / 914 Technical Questions
- 8 years ago.
- Last replied by George Little
- • 23 replies
-
Air- (Windmill-) Starts with "Soft Start"
- by Jeffry Stetson
- in 912 / 914 Technical Questions
- 2 years ago.
- Last replied by Rotax Wizard
- • 1 reply
-
Fuel Flow in rotax 914
- by Marcelo G Martins
- in 912 / 914 Technical Questions
- 2 years ago.
- Last replied by James Ott
- • 3 replies
-
914 TCU set up problem
- by todd linkous
- in 912 / 914 Technical Questions
- 6 years ago.
- Last replied by Robert Mykytiuk
- • 10 replies
-
912 ULS UNSTABLE RPM
- by KAIO
- in 912 / 914 Technical Questions
- 2 years ago.
- Last replied by KAIO
- • 8 replies
-
Vacuum gauge dampening orifice size for sync gauges
- by Byron Mills
- in 912 / 914 Technical Questions
- 2 years ago.
- Last replied by Byron Mills
- • 4 replies