ROTALK Forum
Welcome, Guest
Ask the community for their best thinking on your 912/914 series Technical Questions.
Topics [912 / 914 Technical Questions]
-
Cylinder studs
- by Sam Purpura
- in 912 / 914 Technical Questions
- 4 years ago.
- Last replied by Rotax-Owner
- • 5 replies
-
Mag check roughness both lanes but not equal.
- by Dave Anderson
- in 912 / 914 Technical Questions
- 4 years ago.
- Last replied by Dave Anderson
- • 11 replies
-
Alloy steel propeller shaft Rotax 912
- by Laurent Buckley
- in 912 / 914 Technical Questions
- 4 years ago.
- Last replied by Bill Hertzel
- • 2 replies
-
Display Percent Power on a G3X for a 914?
- by Craig E Maiman
- in 912 / 914 Technical Questions
- 4 years ago.
- Last replied by Craig E Maiman
- • 4 replies
-
Low Fuel Pres w/Mech Pump
- by Mark Bearss
- in 912 / 914 Technical Questions
- 4 years ago.
- Last replied by Roger Lee
- • 11 replies
-
Engine TBO extension and/or overhaul
- by Frank B.
- in 912 / 914 Technical Questions
- 4 years ago.
- Last replied by Rotax-Owner
- • 2 replies
-
year of manufacture
- by jay white
- in 912 / 914 Technical Questions
- 4 years ago.
- Last replied by RotaxOwner Admin
- • 1 reply
-
Idle RPM not responding during adjustment
- by Ray
- in 912 / 914 Technical Questions
- 4 years ago.
- Last replied by Tyler Hathaway
- • 2 replies
-
Required 5-Year Rubber Component Replacement ???
- by Jack Alderman
- in 912 / 914 Technical Questions
- 14 years ago.
- Last replied by Tyler Hathaway
- • 15 replies
-
Engine turns over but will not start.
- by Stephen LaPoint
- in 912 / 914 Technical Questions
- 4 years ago.
- Last replied by Bill Hertzel
- • 3 replies
