912 ULS lubrication sys.

by zar nehzat in General Tech Discussion 11 years ago

hello everybody
I need to know for installation of a 912 ULS oil system, where the exact position of tank and oil cooler have to be in relation of each other and oil pump?
thanks a lot

Re: 912 ULS lubrication sys.

by Rob Seaton » 11 years ago

Rob Seaton

3 1.32k 251

Zar,
- The oil level in the tank should be approximately in-line with the oil pump: A quick reference is the large clamp (holding the lid) is approximately at the same level as the crankshaft (valve cover screws are a good reference for this position)
The official location is between 0mm and -400mm from the center of the propshaft.
The "Note" on page 79-00-00 section 2.3 of the 912 installation manual is an error. (the tank would be too low if the clamp was 360mm below the propshaft)
- THe oil cooler should have the fittings UP. It should be located below the oil pump.
Rob

Thank you said by: zar nehzat

Report

You do not have permissions to reply to this topic.

Related Topics

Title	Category	Replies
Kitfox 3 with 912 1300 hrs on engine	912 / 914 Technical Questions	5
Rotax 912iS Regulator B w/ Grey Connector	Parts	0
912iS Fine filter fittings	912iS Technical Questions	3
Troubleshooting Ignition issues 912UL	912 / 914 Technical Questions	20
EGT Monitoring on 912ULS--Why only 2 of 4 cylinders?	912 / 914 Technical Questions	11