Flash ECU software to recent update

Re: Flash ECU software to recent update

by Jonas Boll » 11 years ago

Jonas Boll

1 6 0

Just a guess, but maybe your aircraft battery isn't powerful enough to supply the required voltage for the computer when it's cranking the starter. Try connecting another battery in parallel?

Re: Flash ECU software to recent update

by Hafeez Ahmed » 11 years ago

Hafeez Ahmed

1 21 0

Dear Rob can I get your personal E-mail for solution of my problems???

Today I start the engine After update the ECU. Stall error does not appear.

Still I am facing a problem, that I am using BUDS to view engine parameters, During the engine start, the connection of Lanes A & B lost. Both lights becomes Red.

and to re connect it again I need to turn off / on the both lane switches one by one.
What will be the probable cause of this failure???

Re: Flash ECU software to recent update

by Hafeez Ahmed » 11 years ago

Hafeez Ahmed

1 21 0

dear jonas, i have already using two batteries in parallel to start the engine, ECU lane voltage shows 12.4 Volts before the engine run.

Re: Flash ECU software to recent update

by Jonas Boll » 11 years ago

Jonas Boll

1 6 0

Ok, sounds good.

I know when I attached my ECU to the BUDS dongle, the software was "glitchy", dropping the connection to Lane A and B very similar to what you describe when I started the engine also. Toggling lane A and B would reconnect just like you describe.

maybe this is normal?
Again, I'm no expert.

Re: Flash ECU software to recent update

by Hafeez Ahmed » 11 years ago

Hafeez Ahmed

1 21 0

Can I get your personal e-mail add???

Yes you are right?? R you still having this problem???