Flash ECU software to recent update
in 912iS Technical Questions
11 years ago
-
Re: Flash ECU software to recent update
by Rob Seaton » 11 years ago
do you have the latest Installation manual? (Edition 1 Revision 1)
there was a wiring error in the previous manual
-
Re: Flash ECU software to recent update
by Hafeez Ahmed » 11 years ago
Dear Rob. I tested all the wiring but Lane connection failure does not dis appears
-
Re: Flash ECU software to recent update
by Rob Seaton » 11 years ago
A Stall fault can be caused by the fuel pumps being switched off. are you getting good fuel pressure?
Note: do not have the backup power switch ON during start; this defeats a self check by the ECU.
Thank you said by: Hafeez Ahmed
-
Re: Flash ECU software to recent update
by Roger Lee » 11 years ago
Did you use the Rotax wiring harness and did you make up much of the wiring yourself? Did you follow the installation manual?
I don't mean for these to sound bad, but just curious in trying to help get to the root of your problem.
Most of the problems have been wiring issues. It may be helpful to grab the installation manual and start following wires from end to end to make sure they are where they are supposed to be.
Roger Lee
LSRM-A & Rotax Instructor & Rotax IRC
Tucson, AZ Ryan Airfield (KRYN)
520-349-7056 Cell
-
Re: Flash ECU software to recent update
by Hafeez Ahmed » 11 years ago
After update the ECU Health Stall error does not appear.
Still I am facing a problem, that I am using BUDS to view engine parameters, During the engine start, the connection of Lanes A & B lost. Both lights becomes Red.
What will be the probable cause of this failure???
You do not have permissions to reply to this topic.
Related Topics