912 ul Coil

by andrew owen in 912 / 914 Technical Questions 6 years ago

Hi , is it possible to replace the ignition leads and plug cap or do I have to replace the coil packs as well? Do they just push in.

Re: 912 ul Coil

by Garrett Wysocki » 6 years ago

Garrett Wysocki

1 572 1.45k

No you do not have to replace the coils.

The ignition leads simply screw/twist into the coil and plug caps. Make sure to use dielectric grease to preserve and seal the electrical connection on each end of the lead.

https://www.permatex.com/products/specialized-maintenance-repair/electrical-system-maintenance/permatex-dielectric-tune-up-grease-2/

https://441py33rout1ptjxn2lupv31-wpengine.netdna-ssl.com/wp-content/uploads/tech_docs/tds/81150.pdf

Report
Re: 912 ul Coil

by andrew owen » 6 years ago

andrew owen

13 17 3

Thanks for that, I take it that the leads are copper and the plug caps are suppressed

Report
Re: 912 ul Coil

by Garrett Wysocki » 6 years ago

Garrett Wysocki

1 572 1.45k

Yes, the caps should measure about 5K ohms.

Report

You do not have permissions to reply to this topic.

Related Topics

Title	Category	Replies
Kitfox 3 with 912 1300 hrs on engine	912 / 914 Technical Questions	5
Rotax 912iS Regulator B w/ Grey Connector	Parts	0
912iS Fine filter fittings	912iS Technical Questions	3
Troubleshooting Ignition issues 912UL	912 / 914 Technical Questions	20
EGT Monitoring on 912ULS--Why only 2 of 4 cylinders?	912 / 914 Technical Questions	11