Question about oil pressure and when it bypasses

Re: Question about oil pressure and when it bypasses

by Aaron » 7 years ago

Aaron

14 129 67

Thank you Garret!

Will take a pic tomorrow morning

Re: Question about oil pressure and when it bypasses

by Aaron » 7 years ago

Aaron

14 129 67

How's it look?

Can someone comment on the fire sleeve below, Is this the right way to do it?

The rotax a&p ia did all the fire sleeve like this. Leave clamp exposeded and looks like high temp rtv on the ends

Thx

IMG_20190310_141754.jpg (You do not have access to download this file.)

Re: Question about oil pressure and when it bypasses

by Aaron » 7 years ago

Aaron

14 129 67

1

IMG_20190310_175508.jpg (You do not have access to download this file.)

Re: Question about oil pressure and when it bypasses

by Garrett Wysocki » 7 years ago

Garrett Wysocki

1 572 1.45k

The crimp looks OK in my opinion. With the fire sleeve I usually push it past the camp, seal it with high temp silicon then cover it with 2" long heat shrink that has an internal heat activated glue.

Re: Question about oil pressure and when it bypasses

by Bill Hertzel » 7 years ago

Bill Hertzel

13 1.95k 8k

A really clean way to finish the ends of the Silicone Fire sleeve is with Fire Sleeve End Tape.
Commonly available under the consumer names of "Self Fusing Silicone Tape",or "Rescue Tape".
It fuses permanently in a few minutes and is as fire Proof as the Fire Sleeve. 500°F+
It makes for a very neat installation.

FireSleeveTape.jpg (You do not have access to download this file.)

---

Bill Hertzel
Rotax 912is
North Ridgeville, OH, USA
Clicking the "Thank You" is Always Appreciated by Everyone.