CDI wiring terminals

Re: CDI wiring terminals

by Roger Lee » 9 years ago

Roger Lee

131 5.38k 5.44k

Hi Jay,

I don't see a picture. One of the Rotax service centers should have any plug for that and pins.
CPS is close for you. Aircraft Spruce owns CPS, but you may have better luck getting that part if you ask for CPS over Spruce.

p.s.
You can send the modules to Lockwood Aviation and they have a tester to check the modules and that will remove all doubt and may save you a lot of time and money.

---

Roger Lee
LSRM-A & Rotax Instructor & Rotax IRC
Tucson, AZ Ryan Airfield (KRYN)
520-349-7056 Cell

Re: CDI wiring terminals

by jay white » 9 years ago

jay white

36 97 23

I think this picture should go through. Its a picture of the bullet connectors (single) on the CDI. I know the CDI is good because it was tested and functions fine. I just can't put it in until I rewire my ignition wire and the red wires from the braided engine cable. those connectors are toast.

Re: CDI wiring terminals

by Rodrigo Echenique » 7 years ago

Rodrigo Echenique

5 19 0

You can contact CARMO ELECTRONICS in Europe, this guys made the Ducati CDI for ROTAX and they have the original connectors, if you can´t do it you can send them your CDI modules and they can change a new wires loom with the connectors.

Re: CDI wiring terminals

by Kevin Stewart » 7 years ago

Kevin Stewart

3 432 1.33k

Bullet style terminals are available here in the USA:
https://www.corsa-technic.com/category.php?category_id=110

They also sell the multiway connectors too. Look up MT style.

Re: CDI wiring terminals

by jay white » 7 years ago

jay white

36 97 23

Wow, Sorry I didn't close this thread ... two years ago, but I forgot. Anyway, the engine was repaired with single bullet connectors and flew fine until I had another issue that grounded me for a while until I replaced the entire engine. It was just that the electrical wiring harness was old and cruddy from 20 plus years of life. I didn't want to chase wires and learn electrical maintenance from scratch so I bought a new motor. It flies just like the old motor only ... newer.
thanks for the info on sourcing.