Replaceing hoses on 912ULS

by in General Tech Discussion 9 years ago

Can anyone advise the amount of time required for a qualified maintenance person to remove all the old hoses and install all the new hoses on a 912ULS.I was told it would probably be 23-25 hours. I would really like to hear from several of you that have done this changeover to help me with this question. Again I thank you for you input. I have been told by one maintenance shop 8 hours total which doesn't make sense to me at all.

Re: Replaceing hoses on 912ULS

by Garrett Wysocki » 9 years ago

Garrett Wysocki

1 572 1.45k

It was closer to 40 hours for me. I did the work myself, replaced all rubber and ended up with a soft lifter which fixed finally fixed itself after some extended ground runs with the oil cooler door closed to heat/thin the oil to get it purged. Could have done it faster if I did it everyday. Was glad I did every rubber component though you can really see the difference when comparing old to new, gives you the confidence of having a like new engine outside of the crankcase.

Thank you said by:

Report

You do not have permissions to reply to this topic.

Title	Category	Replies
EGT Monitoring on 912ULS--Why only 2 of 4 cylinders?	912 / 914 Technical Questions	11
912ULS carb overflowing	912 / 914 Technical Questions	20
Rotax 912ULS Main Bearings	912 / 914 Technical Questions	1
912ULS in a Tecnam Bravo	912 / 914 Technical Questions	4
Rotax 912ULS	Engines	0