Flange nuts

by Marv Kea in General Tech Discussion 10 years ago

Is there a tool for drawing the flange nuts into the prop hub? Did not locate anything in the search area. I have a 912uls with a 2 inch spacer. I also didn't see any instructions In the installation manual on installing the nuts.

Re: Flange nuts

by Roger Lee » 10 years ago

Roger Lee

131 5.38k 5.44k

Hi Marv,

Most of the time these can just be drawn in with the tightening of the bolts. Depending on your setup sometimes they can be GENTLY tapped in place.
Some inserts are threaded and the the bolt heads get safety wired.

Many use Nyloc lock nuts on them with Nord lock washers under the bolt head and under the nut. A setup like this will never come loose.

Roger Lee
LSRM-A & Rotax Instructor & Rotax IRC
Tucson, AZ Ryan Airfield (KRYN)
520-349-7056 Cell

Thank you said by: Marv Kea

Report

You do not have permissions to reply to this topic.

Related Topics

Title	Category	Replies
Prop flange rust?	General Tech Discussion	17
Optional Accessories Integration Requirements on Drive Flange - SI-PAC-023	915iS Technical Questions	2
Round-neck nuts instillation	912 / 914 Technical Questions	6
Copper Nuts Exhaust Flanges	912 / 914 Technical Questions	5
Carb flange	912 / 914 Technical Questions	0