912iS Electric Problem
in 912iS Technical Questions
4 years ago
-
Bill Hertzel
Rotax 912is
North Ridgeville, OH, USA
Clicking the "Thank You" is Always Appreciated by Everyone.
-
Good day Michael, sorry to hear you are AOG, always a PIA.We ended up having three problems.1. The 8 pin molex that goes into the HIC connector PCB had 3 loose connectors. Van's is coming out with a SB with a new connector (they sent us a new one).2. The HIC connector PCB had a problem and we had to buy a new one.3. The #2 pump would run intermittently.Rotax has had a number of those pumps fail and have several SB's on them. We also lost the LED's in the switches from coming on; not a big deal as they only show switch position, but something changed with them.To trouble shoot:I would check the 8 pin molex connector that the pins are seated properly and wiggle it with the pump switch on to see if it will make contact.This one is a PIA; swap the connectors on the pumps, so #1 switch controls #2 pump and #2 switch controls #1 pump; that should tell ya if ya have a bad pump or the switching is bad.Good luck with it and Cheers BarryBarry MarzReplyForward
