Fuse Box lights ON

by Sid Lloyd in 912iS Technical Questions 7 years ago

So the fuse box for the 912iS has a long row of green LED lights. Even when my master power switch is turned off, this long row of LED lights remain lit. Is this normal? This is my first iS and it's in an Aeroprakt A22.

Thanks,

Sid Lloyd

Re: Fuse Box lights ON

by Bill Hertzel » 7 years ago

Bill Hertzel

13 1.95k 8k

The engine will be power under 3 conditions.
1. It is running.
2. Start Power is applied.
3. Backup/Emergency Power is applied.

I will assume the engine is not running when you are looking at the lights.
Start power should only be applied Immediately before an engine start and removed a few seconds later.
Backup/Emergency Power is normally only applied in the event of a double generator failure.

Both START and BACKUP Power connect to the Fuse Box through the Round X3 connector. The Right-Most one of the three.
If the Lights go out with the X3 connector disconnected, check to see if the Start Power or the Backup Power Switches are ON.

If you have a Key Switch that is OFF-ON-START, it may need to be set to the OFF position when not actually starting.

When the lights are ON the engine sensors are Powered,
If it isn't running, the Battery is being drained.

Bill Hertzel
Rotax 912is
North Ridgeville, OH, USA
Clicking the "Thank You" is Always Appreciated by Everyone.

Report

You do not have permissions to reply to this topic.

Related Topics

Title	Category	Replies
EngiBOX Installation on 582 UL	2 Stroke Technical Questions	4
SB on Engine and Gear Box hardness	915iS Technical Questions	4
Mandatory inspection and/or replacement of the crankcase and/or gearbox housing for ROTAX® engine types 912 iS, 915 iS, and 916 iS fuel-injected engines.	General Tech Discussion	37
Is It Possible To Lookup Gearbox Serial Number Using Engine Serial Number?	912iS Technical Questions	6
Is It Possible To Lookup Gearbox Serial Number Using Engine Serial Number?	912iS Technical Questions	2