ROTALK Forum
Welcome, Guest
Ask the community for their best thinking on your 912/914 series Technical Questions.
Topics [912 / 914 Technical Questions]
-
914 running rough ... Help, please.
- by ALEJANDRO RENDON
- in 912 / 914 Technical Questions
- 11 years ago.
- Last replied by Mike Goodrich
- • 10 replies
-
Rotax912ul sputters when reducing throttle
- by jan kerstens
- in 912 / 914 Technical Questions
- 11 years ago.
- Last replied by Roger Lee
- • 4 replies
-
Measuring fuel pressure from clamp block
- by Tom Delaney
- in 912 / 914 Technical Questions
- 11 years ago.
- Last replied by Rob Seaton
- • 3 replies
-
iridium plugs
- by Bob Hartunian
- in 912 / 914 Technical Questions
- 11 years ago.
- Last replied by Roger Lee
- • 1 reply
-
Oil pump assembly 912S
- by Stephan Cassel
- in 912 / 914 Technical Questions
- 11 years ago.
- Last replied by Rob Seaton
- • 4 replies
-
Electronic carb sync device vs. vacume guage type
- by Al C
- in 912 / 914 Technical Questions
- 13 years ago.
- Last replied by Roger Lee
- • 21 replies
-
Oil press. reading stays at 47PSI with engine off
- by Richard George
- in 912 / 914 Technical Questions
- 11 years ago.
- Last replied by Roger Lee
- • 3 replies
-
Evans antifreeze
- by Dennis Moore
- in 912 / 914 Technical Questions
- 11 years ago.
- Last replied by Al C
- • 3 replies
-
Should lower oil fitting flex a little ... or not?
- by Al C
- in 912 / 914 Technical Questions
- 11 years ago.
- Last replied by Roger Lee
- • 1 reply
-
912 UL (80hp) - First start of the day
- by Nick Anon
- in 912 / 914 Technical Questions
- 11 years ago.
- Last replied by Roger Lee
- • 5 replies
