rotax912uls carb

that's right!

We've reported that conversion error, it will be corrected in the next revision of the manual. Thanks! 

Bill Hertzel wrote:

Once again, All the questions can be answered by refering to the 912ULS Installation Manual.

See Section 73-00-00, Chapter 2.2, Page 15.

Excerpt: 
Tightening Torque = 4 Nm (3.32 lb ft) (Suitable for 1.5 mm (.06 in.) Steel wire).  (<---<<<  ERROR!)

 - - -

ADMIN !!!

The 912is Manual is Correct.

The 912ULS Manual Incorrectly converted 4 Nm to 3.32 Lb∙ft .... 4 Nm = 2.95 lb∙ft. = 35.4 in∙lb

Thank you for your pointing out.

The question was resolved!