fbpx
Jump to Forum..

912ULS MAG DROP

in 912 / 914 Technical Questions 6 years ago

When testing ignition A & B at 4000 rpm I get a drop on both of 1000 rpm.  The same drop on A and on B.  Any ideas?

  • Re: 912ULS MAG DROP

    by » 6 years ago

    It may be trigger coil faulty, check trigger coil or Trigger coil gap issue.

     trigger coil air gap .020"

    Gap  greater than .035". It will stop firing or MAG drop. Check it and tell again.

    'Stay home and say thank you

     

      
    Report

  • Re: 912ULS MAG DROP

    by » 6 years ago

    That much of a drop might indicate you are running on 3 cylinders and the bad A plug is in a different cylinder than the B.

    Look at your EGT temps to identify the culprit.

    If you do not have EGT's try an IR temp gun, or just start it on one mag at a time for 10 seconds and see which exhaust pipe stays cold.

    Bill Hertzel
    Rotax 912is
    North Ridgeville, OH, USA
    Clicking the "Thank You" is Always Appreciated by Everyone.

      
    Report
You do not have permissions to reply to this topic.
Related Topics
Title Category Replies
Sudden drop in RPM while changing fuel tank 912iS Technical Questions 3
EGT Monitoring on 912ULS--Why only 2 of 4 cylinders? 912 / 914 Technical Questions 11
912ULS carb overflowing 912 / 914 Technical Questions 20
Rotax 912ULS Main Bearings 912 / 914 Technical Questions 1
912ULS in a Tecnam Bravo 912 / 914 Technical Questions 4