fbpx
Jump to Forum..

Throttle arm throw uneven

in 912 / 914 Technical Questions 7 years ago
I'm having a peculiar situation where I will mechanically sync carbs on the low end / idle. Then when I go to full throttle one is to the stops while the other is off by 1/16". My idle stops are set the same I counted threads and did them on the bench. Its almost like they're not going the same distance.


Also is there a preferred set of gauges people like for carb syncing?

  • Re: Throttle arm throw uneven

    by » 7 years ago

    Most just use 2.25 liquid filled gauges that range from 0-30 on the vacuum.
    If you are 1/16" at WOT that probably isn't an issue. By the time it's that close to touching the throttle stop the carb is wide open. So long as they are in sync up at the higher rpms versus the 2500 the book says.
    If you wanted to play with the cable setup and sync the carbs again it's up to you. You could try and see if it would make that 1/16" difference.

    Roger Lee
    LSRM-A & Rotax Instructor & Rotax IRC
    Tucson, AZ Ryan Airfield (KRYN)
    520-349-7056 Cell

      
    Report
You do not have permissions to reply to this topic.
Related Topics
Title Category Replies
Fuel Pressure Alarm Settings 912iS Technical Questions 0
Bing 64 Throttle Butterfly Installation Confusion 912 / 914 Technical Questions 4
Help with Rotax 582 EGT Imbalance (Needle Settings and Partial Throttle Issues) 2 Stroke Technical Questions 1
HIC to Garmin GEA 24 915iS Technical Questions 5
Carb sync varies over throttle range 912 / 914 Technical Questions 5