fbpx
Jump to Forum..

Oil Pressure lamp on after oil change

in 912 / 914 Technical Questions 8 years ago
Hi all, I am new to the DIY oil change world. I have a 912ULS & I completed "my" first oil change today. On start up the OP registered fine at 5 bar (top o the green). Unfortunately the Oil pressure light stays on despite 3 starts/ 1 min runs. Bit stumped, good pressure on the gauge, but warning lamp won't go out. All guidance appreciated! Cheers, Brian

  • Re: Oil Pressure lamp on after oil change

    by » 8 years ago

    Hi Brian,

    My first thought is the wire connection on the sender, check oil level and depending on how you did the oil change a lot of air in the system? Did you follow the Rotax oil change procedures?

    Roger Lee
    LSRM-A & Rotax Instructor & Rotax IRC
    Tucson, AZ Ryan Airfield (KRYN)
    520-349-7056 Cell

      
    Report
You do not have permissions to reply to this topic.
Related Topics
Title Category Replies
Fuel Pressure Alarm Settings 912iS Technical Questions 0
How does the TCU reads the fuel pressure? 912 / 914 Technical Questions 2
Oil tank flare nut torque value General Tech Discussion 2
Oil tank flare nut torque value General Tech Discussion 1
What thread is that on my new oil cooler? 912 / 914 Technical Questions 1