fbpx
Jump to Forum..

Pipe/thread joint compound

in 912 / 914 Technical Questions 10 years ago
Rotax 912 - What's the model number of that pipe/thread joint compound that is used where the pipe threads into the coolant pump?

Thanks
Tony

  • Re: Pipe/thread joint compound

    by » 10 years ago

    Loctite 648 is a good choice. Make the coolant elbow and flange it screws into for the proper alignment before you take it off the engine. Clean the threads well and wipe with laquer thinner. Then apply the Loctite. Screw it in place with your alignment marks and allow it to cure. Loctite 648 should keep it from coming lose again.

    Roger Lee
    LSRM-A & Rotax Instructor & Rotax IRC
    Tucson, AZ Ryan Airfield (KRYN)
    520-349-7056 Cell

      
    Report
You do not have permissions to reply to this topic.
Related Topics
Title Category Replies
Maintenance schedule, ball joints, ball joint conversion kit 2 Stroke Technical Questions 1
Exhaust joint leaks 912 / 914 Technical Questions 2
Spark plug anti-seize vs heat-sink-compound? 912 / 914 Technical Questions 4

info@rotax-owner.com