Oil pump , spring...

by waldo pons in 912 / 914 Technical Questions 10 years ago

Hi all, thanks for this site, lot of useful information.
Im planning to replace the oil pump spring, ball and screw, do I need to purge the oil system after performing this.
Should I use loctite on the oil pump screw.Any other recommendations.

Thanks...

Re: Oil pump , spring...

by Rob Seaton » 10 years ago

Rob Seaton

3 1.32k 251

If you follow exactly the wording of SI-912-018 Purging of oil system, yes you need to purge the oil system. But, the intent/spirit of the SI is to avoid draining of the lifters by leaving the oil galleries open for a extended period of time (example would be removing the ball/spring/screw and then going for dinner/movie) or introducing a large quantity of air into the oil gallery (example: draining oil cooler and then starting engine)
By the strict letter of law you need to purge but if you remove and replace the ball/spring/screw without any delay you will not introduce any more air than a simple oil filter change and this is not problem.

Report
Re: Oil pump , spring...

by MARK JACKSON » 10 years ago

MARK JACKSON

12 332 11

Hi Waldo

Don't use any loctite or sealant, just torque it 25Nm and then wire lock it.

Mark

Thank you said by: waldo pons

Report

You do not have permissions to reply to this topic.

Title	Category	Replies
Oil tank flare nut torque value	General Tech Discussion	2
Oil tank flare nut torque value	General Tech Discussion	1
What thread is that on my new oil cooler?	912 / 914 Technical Questions	1
Oil Analysis specific for rotax suggestions	General Tech Discussion	7
Would larger oil hose size increase cooling?	General Tech Discussion	4