fbpx
Jump to Forum..

oil lines

in 912 / 914 Technical Questions 11 years ago
Trying to setup my new 912 using the 332-8 aeroquip hose (1/2") and slip on fitting that came with the engine from the dealer. The problem is that I can't get the hose on to the fittings. The fittings are the correct ones for the oil cooler, tank & suction for the oil pump. What am I doing wrong? Is this the correct hose to be using?

  • Re: oil lines

    by » 11 years ago

    1/2" (13mm) is the correct size. Some hose like Aeroquip has no give and it was designed for a specified fitting type. Some just push it over a barbed fitting. On your oil tank the flared end on the oil tank fitting make make it a little harder to push on. Try some universal lube, "spit" on it and try again. It will fit, but may be a little snug. If the hose is cold warm it up first with a heat gun and try again.

    Roger Lee
    LSRM-A & Rotax Instructor & Rotax IRC
    Tucson, AZ Ryan Airfield (KRYN)
    520-349-7056 Cell

    Thank you said by: William Holloway
      
    Report

  • Re: oil lines

    by » 11 years ago

    I had problem with this. You should warm up hoses, lubricate them. In hard cases I used a piece of hard plastic foil to fit hose. I made cone on fitting, lubricate it and it's helps me to slide hose on fitting. You have to remove foil after.
      
    Report
You do not have permissions to reply to this topic.
Related Topics
Title Category Replies
Oil tank flare nut torque value General Tech Discussion 2
Oil tank flare nut torque value General Tech Discussion 1
What thread is that on my new oil cooler? 912 / 914 Technical Questions 1
Oil Analysis specific for rotax suggestions General Tech Discussion 7
Would larger oil hose size increase cooling? General Tech Discussion 4