582 oil injection set up
in 2 Stroke Technical Questions
11 years ago
Hey guys , I have fitted the new 582 in the lightwing LW-1 and I am now at the oil injection set up/ mount stage(as old 582 was pre-mix).
My problem is the oil injection reservoir fitment, There is not a lot of room under the hood to mount it as shown in pic on top of the head. however I have enough room to fit it between the fire wall and engine.
With the plane sitting on its tail wheel( not level) the bottom of the reservoir sits just slightly higher than the intake on the oil pump. The fitment instructions says the oil reservoir is gravity fed to the pump , I'm worried about take off as it would certainly be lower.
My thoughts are it is fine as the pump should pump oil regardless of reservoir hight and as the reservoir is higher when engine is shut down there will be no air bubbles.sound right?
Also do you need to purge the vent screw before EVERY start up?
No worries thank guys
My problem is the oil injection reservoir fitment, There is not a lot of room under the hood to mount it as shown in pic on top of the head. however I have enough room to fit it between the fire wall and engine.
With the plane sitting on its tail wheel( not level) the bottom of the reservoir sits just slightly higher than the intake on the oil pump. The fitment instructions says the oil reservoir is gravity fed to the pump , I'm worried about take off as it would certainly be lower.
My thoughts are it is fine as the pump should pump oil regardless of reservoir hight and as the reservoir is higher when engine is shut down there will be no air bubbles.sound right?
Also do you need to purge the vent screw before EVERY start up?
No worries thank guys