B box with clutch

by James OKane in 2 Stroke Technical Questions 12 years ago

I was reading on another forum site about adding a clutch to a 582. I read that it can only be done to a C box. How difficult is it to replace the B box and add a C box with clutch?

K. O

Re: B box with clutch

by bill martin » 12 years ago

bill martin

10 757 0

James,

If you are mechanically inclined, installing the C box with clutch is no problem. The gearbox comes with installation instructions. The most difficult part will be removing the gear from the crank. If you have access to a Rotax gear puller, it simply screws into the gear and a center bolt is turned to pop the gear loose. This is the safest way to go. I have used claw type and clamshell type automotive pullers but you must be careful not to damage the oil seal behind the gear. The gear usually pops off like a rifle shot when it finally lets go.

The rest is easy. Eight big bolts, a handful of small ones in the front half, and you are in business. No adjustments, no shims, no feeler gauges necessary.

If you have a float plane or a powered parachute, the clutch is a great addition.

Bill.

Thank you said by: Matjaz

Report

You do not have permissions to reply to this topic.

Related Topics

Title	Category	Replies
EngiBOX Installation on 582 UL	2 Stroke Technical Questions	4
SB on Engine and Gear Box hardness	915iS Technical Questions	4
Mandatory inspection and/or replacement of the crankcase and/or gearbox housing for ROTAX® engine types 912 iS, 915 iS, and 916 iS fuel-injected engines.	General Tech Discussion	37
Is It Possible To Lookup Gearbox Serial Number Using Engine Serial Number?	912iS Technical Questions	6
Is It Possible To Lookup Gearbox Serial Number Using Engine Serial Number?	912iS Technical Questions	2