A bit of perhaps helpful clarity ...
The built-in power electrical power source is an alternator, though Rotax itself often refers to it in most places as a generator as do many others in discussions.
A generator rotates the power coils (armature) in a stationary fixed magnetic field.
An alternator has stationary power coils (stator) with rotating magnetic field creator. This is the case for the Rotax! The crankshaft rotates a disk containing permanent magnets inside stationary power coils. But since it uses permanent magnets rather than an excited field coil, it's more-accurately called a MAGNETO! One place Rotax labels it so is in the Illustrated Parts Manual where they call this rotating disk a MAGNETO!
Compared to a typical excited-field alternator, magnetos can't produce nearly the power because the magnetic field of (cheap) permanent magnets is quite low. Hence the 250W rating on this one, just like my 1998 Ducati.
On the other hand, without excited fields, a magneto will charge a completely dead battery, which a normal alternator has a problem doing. A magneto however, acts like a generator in that output is very rpm dependent, so you need the ~5k rpm to get full output of 18A. (Though more than 12A continuous is a hazard to Italian stator windings in the poorly cooled 912/914 setup).
This led to a couple of other realizations. One is that my alternator on/off switch is killing the power from the stator coil circuit, not the field coils, because a MAGNETO doesn't have them! Another is that MAG A & B switches for the 912/914 really are what they say. Since we have CD ignition modules, I'd assumed that the labels came from quaint airplane tradition. But no, the electronic ignition modules really are powered by a magneto after all.
-
Thank you said by: Sean Griffin
-
Thank you said by: Rotax Wizard
-
-
37621_2_MMH sec 24.jpg (You do not have access to download this file.)37621_2_MMH sec 24 dis.jpg (You do not have access to download this file.)
Thank you said by: Sean Griffin
-
Thank you said by: Sean Griffin